Operation Manual

HL 92, HL 92 K
English
17
Starting the Engine
N Press the manual fuel pump
bulb (5) at least five times – even if
the bulb is already filled with fuel.
Cold engine (cold start)
N Turn choke knob (6) and then push
it in at g
Also use this setting if the engine has
been running but is still cold.
– Turn throttle set wheel in direction of
+ as far as stop.
Hot engine (hot start)
N Choke knob (6) remains in F
position.
Cranking
N Place the unit on the ground: It must
rest securely on the engine support
and the gearbox housing.
N On units with an adjustable cutter
bar and defined transport position:
Set the cutter bar to the straight (0°)
position.
N If fitted: Remove blade scabbard
from the cutting blades.
To reduce the risk of accidents, check
that the cutting blades are not touching
the ground of any other obstacles.
N Make sure you have a firm footing,
either standing, stooping or
kneeling.
N Hold the unit firmly on the ground
with your left hand and press down
– do not touch the throttle trigger,
lockout lever or stop switch.
NOTICE
Do not stand or kneel on the drive tube.
N Hold the starter grip with your right
hand.
Version without ErgoStart
N Pull the starter grip slowly until you
feel it engage and then give it a brisk
strong pull.
Version with ErgoStart (C-E)
N Pull the starter grip slowly and
steadily.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until the engine
runs.
As soon as the engine runs
At temperatures below +10°C
Warm up the engine for at least
10 seconds in position g.
At temperatures above +10°C
Warm up the engine for at least
5 seconds in position g.
5
0208BA029 KN
2.
1.
0208BA030 KN
6
1191BA014 KN
1191BA015 KN