Instruction Manual
HL 94, HL 94 K
English
17
Cranking
N Place the machine on the ground: It
must rest securely on the engine
support and the gearbox housing.
N On units with an adjustable cutter
bar and defined transport position:
Set the cutter bar to the straight (0°)
position.
N If fitted: Remove blade scabbard
from the cutting blades.
To reduce the risk of accidents, check
that the cutting blades are not touching
the ground of any other obstacles.
N Make sure you have a firm footing,
either standing, stooping or
kneeling.
N Hold the machine firmly on the
ground with your left hand and press
down – do not touch the throttle
trigger, lockout lever or stop switch.
NOTICE
Do not stand or kneel on the shaft.
N Hold the starter grip with your right
hand.
Version without ErgoStart
N Pull the starter grip slowly until you
feel it engage and then give it a brisk
strong pull.
Version with ErgoStart (C-E)
N Pull the starter rope slowly and
steadily.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until the engine
runs.
As soon as the engine runs
At temperatures below +10°C
Warm up the engine for at least
10 seconds in position g.
At temperatures above +10°C
Warm up the engine for at least
5 seconds in position g.
N Depress throttle trigger lockout and
pull the throttle trigger – the choke
knob moves to the run position F.
Warm up a cold engineat varying
speeds.
WARNING
Make sure the carburetor is correctly
adjusted. The cutting blades must not
move when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
N Depress the momentary contact
stop switch – the engine stops –
release the stop switch – it springs
back to the run position.
Other Hints on Starting
Engine stalls in cold start position g.
N Depress throttle trigger lockout and
pull the throttle trigger – the choke
knob moves to the run position F.
N Continue cranking in position F until
the engine runs.
1191BA014 KN
1191BA015 KN
1191BA025 KN