Instruction Manual

HL 94, HL 94 K
English
13
Fuel filler cap
WARNING
When fueling on a slope, always position
the machine with the filler cap facing
uphill.
N Place the machine on level ground
so that the filler cap is facing up.
N Before fueling, clean the filler cap
and the area around it to ensure that
no dirt falls into the tank.
Open the tank cap.
N Turn the cap counterclockwise until
it can be removed from the tank
opening.
N Remove the cap.
Filling up with fuel
Take care not to spill fuel while fueling
and do not overfill the tank.
STIHL recommends you use the STIHL
filler nozzle for fuel (special accessory).
N Fill up with fuel.
Close the tank cap.
N Place the cap in the opening.
N Turn the cap clockwise as far as
stop and tighten it down as firmly as
possible by hand.
Angle Adjuster - 145°
The angle of th cutter bar can be
adjusted upwards in 4 stages from 0°
(straight) to 55°, and downwards in 7
stages from 0° to 90° (right angle facing
down). There are therefore 12 possible
working positions.
WARNING
To reduce the risk of injury, carry out the
adjustment only when the cutting blades
are at a standstill – engine at idle speed.
WARNING
The gearbox gets hot during operation.
To reduce the risk of burn injury, do not
touch the gearbox.
Fueling
0208BA019 KN
0208BA020 KN
0208BA021 KN
Adjusting the Cutter Bar
0000-GXX-1683-A0
145°