Instruction Manual
HL 94, HL 94 K
English
10
Swing the cutter bar in an arc towards
the outside of the hedge so that the
cuttings are swept to the ground.
Recommendation: Only cut hedges that
are no more than chest high.
The following STIHL attachments may
be used with the basic power tool:
Mounting the Loop Handle (HL 92,
HL 94)
Loop handle is required on versions with
long drive tube (HL 92, HL 94).
N Place the clamp (1) in the loop
handle (2) and position them both
against the drive tube (5) between
the carrying ring (3) and handle
hose (4).
N Position the clamp (6) against the
shaft.
N Line up the holes.
N Insert the screws (7) with
washers (8).
N Fit the square nuts (9) and screws.
388BA033 KN
Approved Power Tool
Attachments
Attachment
1)
Loop handle required on versions
with long drive tube (HL 92, HL 94)
2)
Must not be mounted to versions
with short drive tube (HL 92 K, HL
94 K)
3)
Loop handle required
Application
HL 0°, 500 mm
1)
Long reach hedge
trimmer
HL 0°, 600 mm
1)
Long reach hedge
trimmer
HL 145°,
500 mm
1)
Long reach hedge
trimmer
HL 145°,
600 mm
1)
Long reach hedge
trimmer
HT
2)
Pole pruner
BF
2) 3)
Cultivator with pick
tines
SP 10 Special harvester
Assembling the Unit
7
8
2
1
6
7
8
9
9
3
5
4
0000-GXX-1679-A0