Instruction Manual

HL 92, HL 92 K
English
22
For periods of about 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Clean the cutting blades, check
condition and spray them with
STIHL resin solvent.
N Fit the blade scabbard.
N Thoroughly clean the machine.
N Store the machine in a dry and
secure location Keep out of the
reach of children and other
unauthorized persons.
Throttle Cable
Checking adjustment of throttle cable
Error: Engine speed increases when
only the throttle trigger is pulled.
N Start the engine.
N Pull the throttle trigger (1) – do not
press down the throttle trigger
lockout (2).
If the engine speed increases or if the
cutting blades run, the throttle cable has
to be adjusted.
N Shut off the engine.
N Have throttle cable adjusted by your
dealer. STIHL recommends an
authorized STIHL servicing dealer.
Maintenance Work
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
Antivibration Element
A vibration-absorbing rubber element is
installed between the powerhead and
the shaft. Have it checked if there are
signs of wear or a noticeable increase in
vibration levels.
Storing the Machine Inspection and Maintenance
by User
2
1191BA023 KN
1
Inspections and Maintenance
by Dealer
0208BA045 KN