Operation Manual

GS 461
English
17
Connect concrete cutter to water supply
network
N Connect concrete cutter to water
supply network (min. 1.5 bar)
N Before starting, open shut-off valve
(arrow) completely
Hold concrete cutter
There are two ways to hold the concrete
cutter during starting.
On the ground
N Place the concrete cutter securely
on the ground – assume a steady
stance- the diamond abrasive chain
must not touch any objects or the
ground
N Press the concrete cutter firmly
against the ground, holding the front
handle with your left hand, thumb
wrapped round the handle
N Place your right foot into the rear
handle
Between the knees or thighs
N Clamp the rear handle between the
knees or thighs
N Grip the handlebar firmly with the
left hand – thumb wrapped around
the handlebar
2411BA025 KN
2411BA020 KN
0001BA021 KN