Operation Manual

GS 461
English
12
Fit diamond abrasive chain
N Fit the diamond abrasive chain
starting at the nose of the guide bar
N Position the guide bar over the
bolts (1) – align drive links so that
the position lines up with the symbol
(arrow)
WARNING
If the drive links are not directionally
aligned one behind the other correctly,
the diamond abrasive chain and chain
sprocket will be damaged beyond repair.
N Position the right locating hole (2)
over the peg of the tensioner slide –
simultaneously place the diamond
abrasive chain over the sprocket
wheel (3)
N Turn screw (4) to the right until there
is very little diamond abrasive chain
sag on the underside of the bar and
the lugs of the drive links engage in
the bar groove
N Refit the chain sprocket cover – and
then screw on the nut by hand until
it is fingertight
N Go to chapter "Tensioning the
diamond abrasive chain"
Moving the guide bar
Only move the guide bar if the diamond
abrasive chain cannot be tensioned
properly.
N Removing the chain sprocket cover
N Remove guide bar with diamond
abrasive chain
N Fit the diamond abrasive chain
starting at the nose of the guide bar
N Position the guide bar over the
bolts (1) – align drive links so that
the position lines up with the symbol
(arrow)
WARNING
If the drive links are not directionally
aligned one behind the other correctly,
the diamond abrasive chain and chain
sprocket will be damaged beyond repair.
N Position the left locating hole (5)
over the peg of the tensioner slide –
simultaneously place the diamond
abrasive chain over the sprocket
wheel (3)
N Turn screw (4) to the right until there
is very little diamond abrasive chain
sag on the underside of the bar and
the lugs of the drive links engage in
the bar groove
N Refit the chain sprocket cover – and
then screw on the nuts by hand until
they are fingertight
N Go to chapter "Tensioning the
diamond abrasive chain"
2411BA013 KN
4
1
1
2411BA0014 KN
4
1
1
2411BA049 KN