Instruction Manual

GS 461
English
27
Anti-vibration elements
check XX
Have replaced by servicing dealer
1)
X
Cooling air intake slits Clean X
Cylinder fins Clean XX
Carburetor
Check idle adjustment – chain must not rotate XX
Adjust idle speed X
Spark plug
Adjust electrode gap X
Replace after 100 operating hours
All accessible screws, nuts and bolts (not adjusting
screws)
2)
Tighten X
Spark arresting screen in muffler
Have checked by dealer
1)
X
Have cleaned; if required have replaced by spe
-
cialist dealer
1)
X
Safety information label replace X
1)
STIHL recommends STIHL servicing dealer
2)
During initial use, tighten the cylinder block screws after 10 to 20 hours of operation
3)
When diamond abrasive chain is mounted or changed
The following maintenance intervals apply for normal operating conditions only. The specified inter
-
vals must be shortened accordingly when working for longer than normal or under difficult cutting
conditions (extensive dust, etc.).
Before starting work At the end of work and/or daily Whenever tank is refilled Weekly Monthly Annually If faulty If damaged As required