Instruction Manual

GS 461
English
25
N Remove cap (1)
N Remove rim sprocket (2)
N Inspect transport profile on the
clutch drum (3) – if there are also
heavy signs of wear, also replace
the clutch drum (3)
Installing rim sprocket
N Fit rim sprocket (2)
N Fit cap (1)
Replacing clutch drum
N Remove cap (1)
N Remove rim sprocket (4)
N Use a screwdriver to remove the E-
clip (2)
N Remove washer (3)
N Remove clutch drum (5) with needle
cage (6) from the crankshaft
Installing the clutch drum
N Clean crankshaft stub and needle
cage and lubricate with STIHL
lubricant (special accessory)
N Slip the needle cage onto the
crankshaft stub.
N Fit clutch drum
N Fit rim sprocket
N Refit washer and E-clip on the
crankshaft
N Fit cap
Maintaining the diamond abrasive chain
After finishing work:
N Remove diamond abrasive chain
and guide bar
N Rinse diamond abrasive chain and
guide bar with water
N Dry diamond abrasive chain and
guide bar
N Spray diamond abrasive chain and
guide bar with STIHL multispray – in
particular the bearing of the
sprocket nose – corrosion
protection
Check diamond abrasive chain regularly
N Check the diamond abrasive chain
for cracks and damaged rivets
N Replace damaged or worn chain
components – contact a servicing
dealer
Never use a dull or damaged diamond
abrasive chain – this leads to increased
physical strain, increased vibration load,
unsatisfactory results and increased
wear.
If cutting performance begins to
deteriorate, check the sharpness of the
diamond abrasive chain, resharpen as
needed. To do this, briefly cut through
abrasive material, e. g., sandstone,
aerated concrete or asphalt.
1
3
2
2411BA041 KN
6
1
5
3
2
4
2411BA042 KN
Maintain and Sharpen
Diamond Abrasive Chain