Instruction Manual

GS 461
English
27
Decompression valve
N Press the button, the
decompression valve will be
opened
The decompression valve is closed
automatically when the engine fires for
the first time. For this reason, press the
button again before each additional
starting attempt.
WARNING
There must not be anyone within the
swivel range of the concrete cutter.
N Simultaneously press the throttle
trigger lockout (2) and throttle
trigger (3) – set Master Control
Lever
Position cold start l
– If engine is cold (even if the engine
has stalled during opening of
throttle after starting)
Position warm start n
– If engine is warm (once the engine
has been running for approx. one
minute)
N Hold and start the concrete cutter
When the engine has turned over for the
first time
N Move the Master Control leve (1) to
the position warm start n
N Press the button on the
decompression valve
N Hold and continue cranking the
concrete cutter
Once the engine is running
N Blip the throttle trigger (2); the
Master Control Lever (1) jumps to
run F and the engine begins to idle
The concrete cutter is now ready for use.
At very low temperatures
N Let the engine warm up briefly with
the throttle slightly open
2411BA023 KN
2
1
2411BA024 KN
STOP
1
2411BA026 KN
STOP
2
1
2411BA027 KN
STOP