Instruction Manual

GS 461
English
19
The STIHL diamond abrasive chain is
suitable for cutting the following
materials:
– Concrete
– Reinforced concrete (with rebar up
to 1/2 inch)
– Cinder blocks
– Masonry, including bricks
– Asphalt and soft stone, such as
sandstone
– Hard stone*, such as granite*
– ductile cast iron pipes*
*) Reduction in cutting performance and
service life are possible
Do not cut any other materials – risk of
property damage, including damage to
the concrete cutter or its chain, and
possibly personal injury.
Chain scabbard
The GS product includes a chain
scabbard that is suitable for covering the
bar and chain.
Removing the chain sprocket cover
N Unscrew nuts (1) from the studs –
nuts are fastened to the chain
sprocket cover so that they are
secured against loss
N Remove chain sprocket cover (2)
N Turn the screw (3) to the left until
the tensioner slide (4) butts against
the left end of the housing slot
Fit diamond abrasive chain
N Fit the diamond abrasive chain
starting at the nose of the guide bar
N Position the guide bar over the
bolts (1) – align drive links so that
the position lines up with the symbol
(arrow)
WARNING
If the drive links are not directionally
aligned one behind the other correctly,
the diamond abrasive chain and chain
sprocket will be damaged beyond repair.
Mount Guide Bar and
Diamond Abrasive Chain
1
1
2411BA011 KN
2
4
2411BA012 KN
3
2411BA013 KN
4
1
1
2411BA0014 KN