Instruction Manual

GS 461
English
18
small ridges that hold the part that is
to be separated in position. Break
these ridges later.
Shaping Pipe
N Secure pipes, round bodies, etc.
against rolling away.
N Mark a cutting line - when
determining the cutting line, avoid
reinforcement, especially in the
direction of the severing cut.
WARNING
Manual cutting along this line requires
particular caution and precision.
N Cut into pipes, round bodies, etc. in
the area at the ends of the cutting
line a short distance, so that the
material does not break away.
N Make the plunge cut very carefully
at the apex and cut outward on both
sides - feed with full cutting depth
along the cutting line – for small
corrections of direction, do not tilt
the diamond abrasive chain, but
always position it anew instead – if
necessary, use wedges and leave
small ridges that hold the part that is
to be separated in position. Break
these ridges later.
Diamond abrasive chain, guide bar and
chain sprocket make up the cutting
attachment.
The cutting attachment that is supplied
has been optimized for the concrete
cutter.
– The pitch (t) of the diamond
abrasive chain (1), chain sprocket
and sprocket nose of the Rollomatic
guide bar must match
– The drive link gauge (2) of the
diamond abrasive chain (1) must be
matched to the groove width of the
guide bar (3)
When pairing components that are not
compatible with each other, the cutting
attachment may become damaged
beyond repair after only a short period of
operation.
Diamond abrasive chain
The correct use of the STIHL diamond
abrasive chain ensures economical use
and avoids accelerated wear.
2411BA008 KN
Cutting Attachment
2411BA009 KN
1
2
3
a
t = a : 2