Instruction Manual

GS 461
English
9
should not move. For directions on how
to adjust idle speed, see the appropriate
section of your instruction manual.
If you cannot set the correct idle speed,
have your STIHL dealer check your
power tool and make proper
adjustments and repairs.
During Operation
Holding and Controlling the Power Tool
Always hold the unit firmly with both
hands on the handles while you are
working. Wrap your fingers and thumbs
around the handles. Your left hand
should grip the front handlebar.
Your right hand should grip the rear
handle. This also applies to left-handers.
With your hands in this position, you can
best oppose and absorb the push and
pull of your concrete cutter without
losing control (see section on reactive
forces).
WARNING
Your STIHL concrete cutter is designed
for hand-held use. Cutting with your
concrete cutter resting on the ground or
other surface can cause excessive wear
to the bracket designed to protect the
bottom of the tank housing. Loss of fuel
and personal injury from fire may result.
Replace damaged or badly worn
brackets immediately.
WARNING
To reduce the risk of serious or fatal
injury to the operator or bystanders from
loss of control, never use the concrete
cutter with one hand.
WARNING
To reduce the risk of cut injuries, keep
hands and feet away from the cutting
tool. Never touch a moving cutting tool
with your hand or any other part of your
body.
WARNING
Clear the area where you are working.
Avoid stumbling on obstacles and watch
out for holes or ditches. Be extremely
cautious when working on slopes or
uneven ground. Take extreme care in
wet and freezing weather (rain, snow,
ice.) Keep in mind that water from the
water attachment may affect footing.
WARNING
To reduce the risk of injury from loss of
control, never work on a ladder or any
other insecure support. Never hold the
machine above shoulder height. Do not
overreach.
Position the concrete cutter in such a
way that your body is clear of the cutting
attachment whenever the engine is
running. Stand to the left of cut while
cutting.
Working Conditions
Operate and start your power tool only
outdoors in a well ventilated area.
Operate it under good visibility and
daylight conditions only. Work carefully.
WARNING
Your concrete cutter is a one-person
machine. Do not allow other persons in
the general work area, even when
starting. Stop the engine immediately if
you are approached.
Use extreme caution when cutting
openings, recesses, etc., someone
could be standing behind them – look
beforehand.
WARNING
Even though bystanders should be kept
away from the running concrete cutter,
never work alone. Keep within calling
distance of others in case help is
needed. Wearing of hearing protection
reduces sound perception. Be alert not
to miss voice signals from co-workers.
2411BA046 KN
2411BA003 KN