Instruction Manual

GS 461
English
23
WARNING
Arcing may occur if the adapter nut (1) is
loose or missing. Working in an easily
combustible or explosive atmosphere
may cause a fire or an explosion. This
can result result in serious injuries or
damage to property.
N Use resistor type spark plugs with a
properly tightened adapter nut.
Installing the spark plug
N Install in the spark plug and tighten
N Press on the spark plug boot (1)
firmly
N Insert the air baffle (2) from above
N Mount filter cover
If the machine is to remain out of use for
approx. 3 months or more
N Drain and clean the fuel tank in a
well ventilated place
N Dispose of fuel in accordance with
the regulations and having regard
for the environment
N Run the engine until the carburetor
is dry, this helps to prevent the
carburetor diaphragms sticking
together
N Remove, clean and dry diamond
abrasive chain and guide bar, and
spray with STIHL multispray – in
particular the bearing of the
sprocket nose – corrosion
protection.
N Thoroughly clean the machine - pay
special attention to the cylinder fins
and air filter
N Store machine in a safe and dry
place. Protect against unauthorized
use (e. g., by children)
N Flip the guide bar – each time the
chain is changed – to avoid uneven
wear, especially at the sprocket
nose and on the bottom
N Periodically clean the water inlet
hole (1), water outlet channel (2)
and bar groove (3)
N Measure groove depth – using the
measuring tool on the file gauge
(special accessory) – in the area
with the greatest wear
If the groove is not at least 6 mm deep:
N Replace guide bar
Otherwise the drive links will grind
against the base of the groove – tie
straps will not lie against the bar.
If the guide bar runs in the cut:
1
000BA045 KN
1
2411BA033 KN
2
Storing the Machine Taking Care of the Guide Bar
2
3
1
2411BA028 KN