Instruction Manual

GS 461
English
10
Cutting round and hollow bodies
N Secure pipes, round bodies, etc.
against rolling away
N Mark a cutting line - when
determining the cutting line, avoid
reinforcement, especially in the
direction of the severing cut
N Make the plunge cut very carefully
N Feed with full cutting depth along
the cutting line – for small
corrections of direction, do not tilt
the diamond abrasive chain, but
always position it anew instead – if
necessary, use wedges and if
necessary, leave small ridges that
hold the part that is to be separated
in position. Break these ridges later
Shaping pipe
N Secure pipes, round bodies, etc.
against rolling away
N Mark a cutting line - when
determining the cutting line, avoid
reinforcement, especially in the
direction of the severing cut
DANGER
Manual cutting along this line requires
particular caution and precision.
N Cut into pipes, round bodies, etc. in
the area at the ends of the cutting
line, so that the material does not
break away
N Make the plunge cut very carefully
at the apex and cut outward on both
sides - feed with full cutting depth
along the cutting line – for small
corrections of direction, do not tilt
the diamond abrasive chain, but
always position it anew instead – if
necessary, use wedges and if
necessary, leave small ridges that
hold the part that is to be separated
in position. Break these ridges later
2411BA007 KN
2411BA008 KN