STIHL GHE 135 L, GHE 140 L EN Instruction manual GHE 135.0 L A GHE 140.
0478 201 8312 A. D20. Cle.
1 0478 201 8312 A 1
2 0478 201 8312 A
Thank you for choosing STIHL. We develop and manufacture our quality products to meet our customers' requirements. The products are designed for reliability even under extreme conditions. STIHL also stands for premium service quality. Our specialist dealers guarantee competent advice and instruction as well as comprehensive service support. We thank you for your confidence in us and hope you will enjoy working with your STIHL product. Dr. Nikolas Stihl IMPORTANT: READ BEFORE USE AND KEEP IN A SAFE PLACE.
Handover confirmation Service confirmation 24 24 2. Notes on the instruction manual Viewing direction: Viewing direction when left and right are used in the instruction manual: the user is standing behind the machine (working position). Section reference: 2.1 General This instruction manual constitutes original manufacturer’s instructions in the sense of EC Directive 2006/42/EC.
EN 3.
4. For your safety 4.1 General These safety regulations must be observed when working with the machine. Read the entire instruction manual before using the machine for the first time. Keep the instruction manual in a safe place for future reference. These safety precautions are essential for your safety, however the list is not exhaustive. Always use the machine in a reasonable and responsible manner and be aware that the user is responsible for accidents involving third parties or their property.
Warning: Risk of electric shock! Particularly important for electrical safety are the power cable, mains plug, On / Off switch and electric cable. Damaged cables, connectors and plugs, or electric cables that do not conform to regulations must not be used, to prevent any risk of electric shocks. Therefore, check the electric cable regularly for signs of damage or ageing (brittleness).
Secure the machine on the load floor using adequately dimensioned fastening material (straps, ropes etc.) at the fastening points described in this instruction manual. (Ö 12.3) Push or pull the machine at walking pace only. When transporting the machine, always observe regional legislation, especially regarding load security and the transport of objects on load floors. 4.5 Before operation Make sure that only persons who are familiar with the instruction manual are permitted to use the machine.
The machine must not be tilted during start-up. Avoid switching the machine on repeatedly within a short period of time; particularly avoid "playing" with the On / Off switch. Risk of motor overheating. Owing to the voltage fluctuations caused by this machine during the start-up, other devices connected to the same circuit may be subject to interference in the case of unfavourable power supply conditions. In this case, appropriate steps should be taken (e.g.
Components or guards that are removed for maintenance operations must be properly reinstalled immediately. if present, by the STIHL spare parts symbol. On smaller parts, only the symbol may be present. Cleaning: Always keep warning and information stickers clean and readable. Damaged or missing stickers must be replaced by new, original plates from your STIHL specialist dealer. If a component is replaced with a new component, ensure that the new component is provided with the same stickers.
5. Description of symbols Caution! Read the instruction manual before initial use. EN Wear hearing protection. Wear safety glasses. Wear work gloves. Rotational direction for adjusting the counterplate. Risk of injury! Keep other persons out of the danger area. Risk of injury! Rotating tools. Keep hands and feet away from apertures when machine is running.
6. Standard equipment Item A B C D E F G H 12 Designation GHE 135 L Upper machine Wheel carrier Shredder bag Screw 5 x 16 GHE 140 L Basic unit with shredder bag GHE 135 L, GHE 140 L Foot Washer A6 Cap nut M6 Qty. 1 1 1 4 1 Item I J K L M N O x Designation Wheel Bolt M8 x 85 Sleeve Washer A8 Lock nut M8 Open-ended spanner Allen key Instruction manual Qty.
7.1 Installing the wheels and feet GHE 140 L: – Fold out the machine. (Ö 10.12) ● Insert bolt (J) with washer (L) from the inside through the bore in wheel carrier (B). Push washer (L) and sleeve (K) onto bolt (J). Push wheel (I) onto sleeve (K). Fit nut (M) with washer (L) and tighten to 5-7 Nm. EN 7. Preparing the machine for operation ● Centre wheel cap (1) on wheel (I) and press in until wheel cap (1) engages. Installing the wheels: – Repeat this procedure on the other side.
7.2 Assembling the machine (GHE 135 L) ● Remove the shredder bag. (Ö 10.6) ● Position upper machine (A) on wheel carrier (B) and carefully centre. Make sure that rubber cover (1) is positioned correctly – rubber cover (1) must not be clamped between the upper machine and the black cover on the wheel carrier. Install upper machine (A) on wheel carrier (B) by screwing in four screws (D). Tighten screws (D) to 11,5 Nm. ● Insert the shredder bag. (Ö 10.5) 7.
8.1 What material can be processed? Tree and hedge cuttings, thujas, spruce branches, branches with side shoots and twigs with leaves, greens, berry bushes, bundled flower material which is not too damp. Tree and hedge cuttings should be processed when fresh, as the shredding performance is better with fresh than with dried-out or wet material. 8.2 What material cannot be processed? Stones, glass, bits of metal (wire, nails, etc.) or plastic must not be fed into the garden shredder.
9. Safety devices The minimum cross-section of the power cable must be 3 x 1.5 mm² for a length of up to 25 m or 3 x 2.5 mm² for a length of over 25 m. 9.1 Motor restart inhibitor The plug connections must be splash proof. The machine can only be started via the switch and not by plugging the electric cable into the mains socket. Unsuitable extension cables lead to a loss of power and may result in damage to the motor. 9.
The garden shredder can only be switched on with the shredder bag locked in place. 10.6 Removing the shredder bag ● Connect the machine to the mains. (Ö 10.1) EN ● Turn locking switch (3) to the right as far as it will go and secure the shredder bag. On/off switch (1) with integrated locking slide (2) prevents direct switching from one rotational direction to the other. Before switching the rotational direction, switch off the machine and wait for the blade roller to come to a standstill.
● Release the rotary switch. This returns automatically to the I position. The motor continues to run. 10.8 Switching off the garden shredder ● Put on thick gloves, safety glasses and hearing protection. ● Connect the power cable to the garden shredder. (Ö 10.2) ● Switch on the garden shredder. (Ö 10.7) Reverse position ● Wait until the garden shredder has reached its maximum speed (idling speed). The blade roller runs in reverse and releases the shredding material again.
10.12 Folding out the machine GHE 140 L EN 10.11 Folding in the machine GHE 140 L 11. Maintenance Risk of injury: Carefully read the section "For your safety" (Ö 4.), particularly the subsection "Maintenance and repairs" (Ö 4.7), and follow all safety instructions exactly before performing any maintenance or cleaning operations on the machine. Disconnect the mains plug before performing any maintenance operations. 11.1 Adjusting the counterplate The machine must be free of shredding material.
Step 2 ● With the machine running, slowly turn adjustment screw (1) clockwise using Allen key (2). This presses the counterplate against the blade roller inside the machine. The counterplate is properly adjusted when a few aluminium shavings fall through the ejection chute. The counterplate is adjusted and the machine is ready for operation. Never spray water onto motor or engine components, seals, bearing points or electrical parts such as switches. This would result in expensive repairs.
● 2nd person: Hold the garden shredder at the left and right of the tubular stand in front of the two feet (4). ● Lift the garden shredder simultaneously. 12.3 Transporting the garden shredder on a load floor ● Hold the garden shredder at the handle (1) and tilt to the rear. ● The garden shredder can be pulled or pushed slowly (walking pace). 12.2 Lifting or carrying the garden shredder At least two persons are always required to lift and carry the machine.
● Secure the machine against slipping using suitable fastening materials. Attach ropes or straps to wheel carrier (1) or feed chute (2). 13.
L/W/H 40 s load time 60 s idle time 64/49/96 cm GHE 135.0 L: In accordance with Directive 2000/14/EC: Guaranteed sound 94 dB(A) power level LWAd In accordance with Directive 2006/42/EC: Sound pressure level 87 dB(A) at workplace LpA 3 dB(A) Uncertainty KpA Power 2000 W Amperage rating 10 A Nominal motor speed 21000 rpm Weight 23 kg GHE 140.
17. Service schedule 17.1 Handover confirmation 17.2 Service confirmation 1 Please hand this instruction manual to your STIHL specialist dealer in the case of maintenance operations. He will confirm the service operations performed in the pre-printed boxes.
Notizseiten.fm Seite 1 Mittwoch, 11.
STIHL GHE 135 L, GHE 140 L 0478 201 8312 A A
