Instruction Manual

0478 201 9915 C - EN
40
* Attention!
Mains fuses of less than 16 A may
frequently trip during start-up of the
machine or when it is operating under
heavy load.
17.1 REACH
REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals.
Information on compliance with the
REACH Directive (EC) No. 1907/2006 is
available from www.stihl.com/reach.
Fault:
Motor does not start
Possible cause:
– Motor overload protection activated
– No mains voltage
– Electric cable, plug, plug connector or
switch defective
– Fuse in UK plug damaged (only applies
to machines for UK)
– Feed chute not properly closed - safety
cut-off switch actuated (safety interlock)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (Ö 8.6)
– Check power cable and fuse
# (Ö 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician) # (Ö 10.1)
– Replace fuse #
– Close feed chute properly and tighten
screws (Ö 11.3)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
(Ö 11.2)
– Reset locking device (Ö 11.4)
Fault:
Frequently tripped mains fuse
Possible cause:
– Unsuitable electric cable
– Power overload
– Machine overloaded
Remedy:
– Use suitable electric cable (Ö 10.1)
– Connect the machine to another circuit
– Reduce quantity of shredding material;
reverse, re-sharpen or replace the
shredding blades # (Ö 11.5)
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
Remedy:
– Reverse, re-sharpen or replace
shredding blades # (Ö 11.5)
19.1 Handover confirmation
Tightening torque
Blade disc
screw
25 Nm
Tightening torque
Reversible blade
screw
10 Nm
L/W/H 77/48/97 cm
Weight 19 kg
19 kg (CH)
20 kg (GB)
Sound emissions:
In accordance with 2000/14/EC / S.I.
2001/1701:
Guaranteed sound
power level L
WAd
104 dB(A)
Uncertainty K
WA
3 dB(A)
In accordance with EN 50434:
Sound pressure level
at workplace L
pA
93 dB(A)
Uncertainty K
pA
3 dB(A)
GHE 105.0
18. Troubleshooting
# If necessary, contact a specialist
dealer; STIHL recommends STIHL
specialist dealers.
19. Service schedule