Instruction Manual

FSE 60, FSE 71, FSE 81
English
40
For periods of 3 months or longer
N Thoroughly clean the machine,
especially the cooling air inlets.
N Take out the spool with nylon lines
and engage the ends of the lines in
the spool's notches. Clean and
inspect the spool.
The resilience and service life of the
nylon line can be increased by storing it
in a container filled with water.
N Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.
Placing Power Tool on the Ground
N Switch off the power tool.
N Lay your trimmer on its back with
the loop handle facing down and the
output shaft facing up.
Adjusting Nylon Line
N Hold the rotating mowing head
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
N The blade (1) on the deflector (2)
trims surplus line to the correct
length – avoid tapping the mowing
head more than once at a time.
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
If the line is shorter than 2.5 cm:
WARNING
To reduce the risk of injury, always shut
off the engine before adjusting the
mowing line by hand.
Storing the Machine Maintaining the Mowing
Head
238BA021 KN
1
232BA007 KN
2