Instruction Manual

FSB-KM
English
10
N Slide the deflector (3) onto the drive
tube (4) so that the bead (a) on the
drive tube engages the guide (b) in
the deflector.
N Push the deflector (3) into position
until the set screw (5) engages.
N Tighten down the clamp screw (6)
firmly.
Placing power tool on the ground
N Switch off the engine.
N Lay your trimmer on its back with
the loop handle and shroud pointing
down and the output shaft facing up.
Thrust plate
The thrust plate is supplied with the
DuroCut 5-2 and the PolyCut 6-3. It is
only required when using these mowing
heads.
Mowing head STIHL AutoCut 5-2,
mowing head STIHL AutoCut C 6-2
N Remove thrust plate (1), if present,
from shaft (2)
Mowing head STIHL DuroCut 5-2,
mowing head STIHL PolyCut 6-3
N Push the thrust plate (1) onto the
shaft (2) by inserting the internal
hexagon (3) onto the hexagon (4)
5
002BA252 KN
3
4
6
b
Mounting the Cutting
Attachment
546BA016 KN
541BA001 KN
1
2
3
4