Operation Manual

FSA 90, FSA 90 R
English
48
N Place the secured assembly on the
handle support (8) with the wing
screw at the side nearest the battery
compartment.
N Push the wing screw into the handle
support as far as stop and then
screw it down – but do not finally
tighten yet.
N Line up the handlebar at a right
angle to the drive tube – check
distance A again.
N Tighten down the wing screw firmly.
Mounting the control handle
N Take out the screw (9) – the nut (10)
remains in the control handle (11).
N Push the control handle onto the
handlebar (7) until the holes (13)
line up – the trigger (12) must point
towards the cutting attachment.
N Insert the screw (9) and tighten it
down firmly.
N Push the corrugated tube (14) into
the retainer (15).
3988BA003 KN
8
11
13
12
3988BA004 KN
10
7
13
9
14
15
3988BA005 KN
14
15