Operation Manual

FSA 90, FSA 90 R
English
47
6 Grass cutting blade 260-2
(260 mm dia.)
7 Grass cutting blade 230-4
(230 mm dia.)
8 Grass cutting blade 230-8
(230 mm dia.)
WARNING
Non-metal grass cutting blades are not
approved.
Deflectors
9 Deflector with line limiting blade
10 Deflector without line limiting blade
Handles
11 Loop handle
12 Loop handle with
13 Barrier bar
14 Bicycle handle
Shoulder strap/harness
15 Shoulder strap may be used
16 Full harness may be used
17 Harness for Type AR battery may
be used together with
18 padding (special accessory)
See chapter on "Fitting the Harness".
Mounting Bike Handle with Swivelling
Handle Support
The machine is supplied with the
swiveling handle support already
mounted on the shaft. To mount the
handlebar it is necessary to remove the
clamp moldings.
Removing the clamp moldings
N Hold the lower clamp (1) and upper
clamp (2) firmly together.
N Release the wing screw (3) – the
clamps are loose once the wing
screw has been released. They are
pushed apart by the two
springs (4 and 5).
N Pull out the wing screw – the
washer (6) remains on the wing
screw.
N Separate the clamp moldings – the
springs (4 and 5) remain in the
lower clamp.
Securing the handlebar
N Place the handlebar (7) in the lower
clamp (1) so that distance A is no
more than 15 cm (6 in).
N Place the upper clamp in position
and hold both clamp moldings
together.
N Push the wing screw through the
two clamps as far as stop – hold all
parts together and secure them.
Mounting the Bike Handle
1
7
A
250BA046 KN