Instruction Manual

1
+
–
1
–
+
2
2
0000-GXX-4601-A0
If the set wheel (1) is turned in "-" direction, the
trigger (2) can no longer be fully depressed. The
power level is lower. The cutting attachment
rotates at a lower RPM.
If the set wheel (1) is turned in "+" direction, the
trigger (2) can still be fully depressed. The power
level is higher. The cutting attachment rotates at
a higher RPM.
► Turn the set wheel (1) to the required position.
12.3 Mowing
The cutting height is determined by the distance
of the cutting attachment from the ground.
A B
0000-GXX-4606-A1
Mowing with a mowing head (A)
► Swing the brushcutter steadily back and forth
in an arc.
► Move forward slowly in a controlled manner.
Mowing with a grass cutting blade (B)
► Mow with the left-hand side on the metal cut‐
ting attachment.
► Move forward slowly in a controlled manner.
12.4 Adjusting Nylon Line
12.4.1 Line Feed on AutoCut Mowing Head
► Tap the rotating mowing head on the ground.
About 30 mm of fresh nylon line is advanced.
The line limiting blade in the deflector trims the
mowing lines to the correct length.
1
2
0000-GXX-4037-A1
Automatic feed will not take place if the mowing
lines are shorter than 25 mm.
► Switch off the trimmer, push retaining latch to
position
and remove the battery.
► Depress the spool (1) on the mowing head
and hold it depressed.
► Pull out the mowing lines (2).
► If the mowing lines (2) cannot be pulled out to
the required length: Replace the spool (1) or
the mowing lines (2).
The spool is empty.
12.4.2 Line Feed on SuperCut Mowing Head
Mowing lines are advanced automatically. The
line limiting blade in the deflector trims the mow‐
ing lines to the correct length.
Automatic feed will not take place if the mowing
lines are shorter than 40 mm.
► Switch off the trimmer, push retaining latch to
position
and remove the battery.
► Pull out the mowing lines.
► If the mowing lines cannot be pulled out to
required length: Replace nylon line.
The spool is empty.
13 After Finishing Work
13.1 After Finishing Work
► Switch off the trimmer, push retaining latch to
position
and remove the battery.
► If the trimmer is wet: Allow the trimmer to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the trimmer.
► Clean the deflector.
► Clean the cutting attachment.
► Clean the battery.
► If a metal cutting attachment is mounted: Fit
the matching transport guard.
14 Transporting
14.1 Transporting the brushcutter
► Switch off the brushcutter, push the retaining
latch to position
and remove the battery.
English 13 After Finishing Work
40 0458-709-9821-D