Instruction Manual

1
2
3
4
5
6
7
0000-GXX-4588-A0
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
7.2 Mounting the Barrier Bar
The barrier bar can only be mounted in combina‐
tion with the loop handle.
► Switch off the trimmer, push retaining latch to
position and remove the battery.
1
2
3 4
5
6
7
8
0000-GXX-4589-A0
► Insert nuts (2) in the barrier bar (1) so that the
holes line up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (5) and
barrier bar (4) on the drive tube (6).
► Hold the clamp (7) against the drive tube (6).
► Insert and tighten down the screws (8) firmly.
7.3 Mounting and Removing the
Deflector
7.3.1 Mounting the Deflector
► Switch off the trimmer, push retaining latch to
position
and remove the battery.
3
1
2
2
0000-GXX-4590-A0
The line limiting blade (1) is already installed in
the deflector (2) and must not be removed.
► Push the deflector (2) into the guides on the
housing as far as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
7.3.2 Removing the Deflector
► Switch off the trimmer, push retaining latch to
position and remove the battery.
2
1
0000-GXX-4591-A0
► Take out the screws (2).
► Pull off the deflector (1).
7.4 Mounting and Removing the
Mowing Head
7.4.1 Mounting the Mowing Head
► Switch off the trimmer, push retaining latch to
position
and remove the battery.
1
2
3
4
1
4
0000-GXX-4592-A0
► Fit the fanwheel (2) on the shaft (3) with fan
blades facing up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise.
► Insert the stop pin (4) in the bore as far as
stop and hold it depressed.
7 Assembling the Trimmer English
0458-709-9821-D 35