Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
91FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
11. Fuel system
11.1 Air filter
– Refer also to troubleshooting,
b 3.6, b 3.7
: Remove screws (1)
: Remove the filter cover (2)
: Remove the air filter (1)
– Examine air filter, clean or
replace if necessary
– see Instruction Manual
– Reassemble parts in reverse
order
5904RA390 TG
1
1
2
5904RA391 TG
1
11.2 Filter housing
– Remove the air filter, b 11.1
Versions with M-Tronic
: Remove plug (1) on diagnostic
connector (arrow)
All versions
: Remove screws (1)
In versions with M-Tronic, the
grommet (2) is not removed
because it is connected to the
switchgear.
: Remove grommet (2)
5904RA394 TG
1
5904RA003 TG
1
1
2
All versions
: Remove tank vent hose (1) at the
connector (arrow) – always use a
new tank vent hose
: Unscrew nuts (1) and pull off filter
housing (2)
: Press out grommet (1) in the
direction of the carburetor
– For versions with M-Tronic:
check the plug of the diagnostic
connector, replace if necessary
5904RA395 TG
1
5904RA396 TG
1 1
2
5904RA397 TG
1