Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
84 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
: Push the torsion spring (1) into
the mount (2) as far as it will go
The bent end (arrow) must rest
against the peg (3).
: Push slide (1) into the mount so
that engages the middle of the
serration (arrow)
: Position handle molding (1),
insert and tighten down the
screws (arrows)
Checking operation
– Check throttle cable setting,
adjust if necessary, b 10.2.4
4902RA125 TG
1
2
3
4902RA126 TG
1
5904RA262 TG
1
10.1.2 Slide control
– Remove control handle for loop
handle, b 10.1
– Remove throttle trigger / throttle
trigger interlock, b 10.1.1
: Remove slide control (1)
: Remove torsion spring (1)
Installation
: Slide torsion spring (1) onto the
post (2) so that the angled
end (arrow) faces upward
5904RA291 TG
1
5904RA292 TG
1
5904RA293 TG
1
2
: Short end (1) must lie between
the ridges (arrows)
: Orient slide control (1) so that the
cam (arrow) faces downward
: Position slide control (1) so that
the cam (2) is seated to the left of
the contact spring (3)
5904RA294 TG
1
5904RA295 TG
1
5904RA296 TG
1
3
2