Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
82 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
10. Actuating levers
10.1 Control handle for loop
handle
The control handle for the loop
handle (1) with slide control (arrow)
is pushed directly onto the drive
tube assembly (diameter 25.4 mm)
and clamped down with clamps.
– Installing and removing the
control handle for the loop
handle, b 10.1
10.1.1 Throttle trigger / throttle
trigger interlock
: Take out the screws (arrows)
: Remove handle molding (1)
5904RA261 TG
1
5904RA262 TG
1
: Remove torsion spring (1) from
the guide (2) and pull out under
the throttle cable (3)
: Remove throttle trigger (1)
: Rotate throttle trigger (1) by 90°
clockwise until the hook (2) rests
against the surface (arrow)
5904RA263 TG
2
1
3
5904RA264 TG
1
5904RA496 TG
1
2
: Thread out the throttle cable (1)
on throttle trigger (2)
: Carefully pull out trigger
interlock (1) – tension on the
torsion spring is released
suddenly
: Remove torsion spring (1)
–The slide control may pop out
5904RA498 TG
1
2
5904RA265 TG
1
5904RA266 TG
1