Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
81FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
: Push the antivibration
housing (1) into the rubber
buffer, so that a circumferential
gap(arrows) of a=6mm
between it and the shroud/
protective hip plate results
– Hold the antivibration housing (1)
in this position
– Through the gap, check that the
rubber buffers are seated
properly
: Tighten screw (1) through the
opening in the support (2)
– Antivibration housing is
clamped and secured
– Position bike handle on
antivibration housing so that the
throttle cable is routed under the
drive tube assembly – narrow
side of the support and clamping
screw must face the cutting
attachment
5904RA253 TG
a
1
5904RA254 TG
1
2
: Orient bike handle (1) so that the
control handle (2) is on the
muffler side
: Slide spring (3) into the mount on
the clamp (4)
Throttle cable must be routed under
the drive tube assembly.
: Position bike handle (1) on profile
of the antivibration housing and
insert clamping screw (2) in the
thread (arrow) and tighten it
5904RA255 TG
1
4
3
2
5904RA256 TG
1
2
: Starting at the engine, insert the
throttle cable (1) in the
guide (arrows)
: Position fairing (1) with the hooks
in the openings (arrows) and
slide toward support (2)
– Insert and tighten down the screw
5904RA257 TG
1
5904RA258 TG
1
2