Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
74 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
: Push starter rope (1) out a short
distance and undo the knot
– Pull the starter rope out of the
rope rotor, starter cover and
starter grip
Installation
: Make the special knot illustrated
in the end of the rope at the
starter grip
: Thread the new starter rope into
the starter grip from above
5904RA200 TG
1
5904RA230 TG4903RA131 TG
: Pull the rope through the grip until
the knot at the end of the rope is
in the recess (arrow)
: Then thread the rope (1) through
the opening (arrow)
: Thread starter rope (1) into rope
rotor
– Secure the rope (1) with a simple
overhand knot
4903RA132 TG5904RA201 TG
1
5904RA202 TG
1
: Insert starter rope (1) in the
recess (arrow) and press the
knot into the depression (2) as far
as it will go
– Install ErgoStart/rope rotor,
b 8.4
– Tension the rewind spring, b 8.6
– Reassemble remaining parts in
reverse order
5904RA203 TG
2
1