Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
70 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
7.5.6 Cut-off speed not
reached
– Check air filter and spark arrestor screen
(if present) in muffler, clean or replace if
necessary, b 11.1, b 5.1
– Check cutting attachment for easy
movement, clean or replace if necessary,
see Instruction Manual
– Calibrate control unit,
b 7.1
Cut-off speed greater
than 12300 rpm?
Maximum speed less than
11500 rpm
– Look for a fault in the fuel
path, check engine for
leaks,
b 11, b 5.2
no
Troubleshooting
completed
yes
– Check screwed
connections of the control
unit leads, b 6.2.1
Connection
and firm seat in the
lug
OK?
– Tighten screwed
connections and push
plug on all the way, if
necessary, replace
switchgear or control unit,
b 7.4, b 6.2.1
no
yes
– Check start detection,
wiring harness and plug
connections, b 7.3
– Replace switchgear,
b 7.4
yes
no
Are target values
attained?