Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
68 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
7.5.4 Ignition – no ignition
spark
no
– Move choke lever to
position }
Troubleshooting
completed
– Check the flywheel,
(two pairs of poles?) b 6.5
Combination
OK?
– Check air gap between
control unit and flywheel,
b 6.2
Establish correct control unit/
flywheel combination
yes
Air gap
OK?
– Test ignition system
according to flow chart
"Ignition system
troubleshooting",
b 6.7
– Set correct air gap,
b 6.2
no
No ignition spark
yes
no
yes
Can engine
be started?