Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
65FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
7.5 Troubleshooting, M-Tronic
7.5.1 Engine does not start
Can engine
be started?
no
– Move choke lever to
position }
Troubleshooting completed
– Check ignition (spark
plug, spark plug boot,
ignition spark), b 6
Ignition spark
present?
– Mechanically check start
detection system; is the
switchgear (microswitch)
actuated by the cam of the
choke lever?
– Clicking noise, b 11.4.5
– Examine switch gear,
clean or replace if
necessary, b 7.4
– Check start detection and
wiring harness electrically,
b 7.3.5, b 7.3.6
yes
Mechanically
OK?
Are target values
attained?, b 7.3
– Look for a fault in the fuel
path, check engine for
leaks, b 11
– Replace switchgear,
b 7.4
no
yes
no
no
Engine does not start
Is it possible to start
the engine?
yes
no
– Check solenoid valve,
b 7.3.4
Are target values
attained? b 7.3.4
– Replace switchgear and/
or carburetor, b 11.3
yes
yes
no
– Test ignition system
according to flow chart
"Ignition system
troubleshooting", b 7.5
yes