Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
63FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
: Orient diagnostic connector (1)
so that the tab faces the
recess (arrow)
: Push the diagnostic
connector (1) into the bushing (2)
as far as it will go
: Insert and tighten screw (1) – firm
seating of the diagnostic
connector is ensured
5904RA176 TG
12
5904RA177 TG
1
Insert the thin leads of the
switchgear first.
: Press red lead (1) and black
lead (2) as far as they will go into
the guides (arrows) on the plug
Run the black lead under the red
lead – for left guide, see illustration
: Press black lead (1) and red
lead (2) as far as they will go into
the guide that is offset by
90° (arrows)
5904RA178 TG
1
2
5904RA179 TG
2 1
: Insert switchgear (1) with the
pegs in the mounts (arrows)
– Insert and tighten down the screw
Run the thick leads to the ignition
module over the thin leads.
: Press red lead (1) and black
lead (2) as far as they will go into
the guides (arrows) on the plug
5904RA180 TG
1
5904RA181 TG
1
2