Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
57FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
Engine runs smoothly,
troubleshooting procedure completed
no
Ignition module
needs to be replaced
b 6.2
yes
no
– Look for fault in fuel or carburetor
system
– Check engine for leaks
– Check position of flywheel on
crankshaft,
b 5.2, b 6.5
yes
Check that the slide control or lever for stop function is working properly:
– Short circuit wire chafed?
Control handle for loop handle
– Function between slide control and contact spring of the microswitch:
– Position "F" = microswitch not pressed
– Position "
0" = microswitch pressed
Control handle for bike handle
– Function between lever for stop function and contact spring:
– Lever for stop function not pressed = no connection
– Lever for stop function pressed = connection
– Replace short circuit wire if necessary,
b 6.6.2
2
3
Powerful spark?
Does engine run?