Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
55FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
6.7 Troubleshooting, Ignition System
Engine does not run
Slide control or lever for stop function:
– Set to position "F" or not pressed?
Check spark plug:
– Smeared with oil, black?
– Sooted?
– Electrode gap correct?
– Contacts shorted (threads)?
– Clean, adjust or replace spark plug,
b 6.3
Check spark plug boot:
– Firmly seated on spark plug (torsion
spring)?
– Torsion spring hook in center of ignition
lead?
– Spark plug boot damaged?
– Replace spark plug boot and/or torsion
spring if necessary,
b 6.4
Check ignition:
with ZAT 3 or ZAT 4
(use ZAT 3 as main spark gap
see TI 32.94),
b 6.3
1