Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
24 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
: Position washers (1) on the pegs
: Orient clutch (2) so that the
markings (arrows) are visible
: Slide clutch (2) onto the pegs on
the lower cover washer (3)
: Position upper cover washer (1)
so that the holes (arrows) match
SM
SM
5904RA026 TG
1
2
1
3
SM
SM
5904RA027 TG
1
: Fit coupling (1) complete with
cover washers in the threaded
holes (arrows) of the flywheel (2)
: Insert and tighten down the
screws (3) SW 10
– Pull the locking strip out of the
cylinder
– Install clutch housing, b 4.1
– Reassemble remaining parts in
reverse order
5904RA028 TG
1
2
3
3