Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
14 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
3.6 Carburetor
Problem Cause Remedy
Carburetor floods; engine stalls Inlet needle not sealing
– Foreign matter in valve seat or
cone
Remove and clean inlet needle or
clean carburetor
Inlet needle worn Replace inlet needle
Inlet control lever sticking on
spindle
Examine control lever, replace if
necessary
Helical spring not located on nipple
of inlet control lever
Remove the inlet control lever and
refit it correctly
Perforated disc on diaphragm is
deformed and presses constantly
against the inlet control lever
Replace metering diaphragm
Metering diaphragm is deformed Replace metering diaphragm
Poor acceleration, version without
M-Tronic
Low speed screw "too lean" Check basic carburetor setting,
correct if necessary
High speed screw "too lean" Check basic carburetor setting,
correct if necessary
... All versions Inlet needle sticking to valve seat Remove inlet needle, clean and
refit
Diaphragm gasket leaking Replace diaphragm gasket
Metering diaphragm damaged or
shrunk
Replace metering diaphragm
Tank vent faulty Replace tank vent
Leak in fuel line between tank and
carburetor
Seal connections or replace line
... Versions with M-Tronic Parts in carburetor or M-Tronic
wiring harness defective
Carry out M-Tronic diagnosis, if
necessary, replace carburetor or
M-Tronic wiring harness