Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
131FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
14. Service accessories
No. Designation Part No. Use
1 STIHL multi-purpose grease 0781 120 1109
2 Grease (225 g tube) 0781 120 1111 Oil seals, sliding and bearing points
8 STIHL gear lubricant for
trimmers
80 g tube
225 g tube
0781 120 1117
0781 120 1118
Gearbox, drive shaft
3 STIHL special lubricant 0781 417 1315 Bearing bore in rope rotor, rewind spring in
starter
4 STIHL press fluid OH 723 0781 957 9000 Rubber elements antivibration elements
5 Tube of sealant Dirko HT red 0783 830 2000 Sealing the crankcase
6 Standard solvent-based
degreasant not containing any
chlorinated or halogenated
hydrocarbons
Cleaning mating surfaces and the carburetor,
cleaning the crankshaft stub and tapers in
flywheel