Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
128 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
: Heat the gearbox (1) in the
location of the bearings on the
drive end (arrows) to approx.
120 °C (250 °F)
: Position drive pinion (2) so that
the bevel gearing faces the gear
housing
: Press in the drive pinion (2) as far
as it will go
– If necessary, turn the output shaft
until the drive pinion engages the
output shaft
The drive pinion must be inserted
quickly, as it absorbs heat and
begins to expand.
2
5904RA534 TG
1
: Insert and tighten down the stud
(1)
Checking operation
: Turn output shaft (1); the inner
serration of the drive
pinion (arrow) must also turn
– Gearbox must turn easily
– Install gearbox, b 12.5.1
1
5904RA535 TG5904RA536 TG
1