Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
120 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
Installation
: Push the line limiting blade (1)
into the mount (arrow)
– Insert and tighten down the screw
To preserve the threads in the
plastic housing, screw the screws
into the existing threads and tighten
carefully.
– Examine gearbox, repair or
replace if necessary – see
"Kombi-Tools" Service Manual
: Position the deflector (1) on the
gearbox
: Insert and tighten down the
screws (2)
5904RA499 TG
1
5904RA500 TG
1 2
22
12.3.3 One-piece carrying ring
: Unscrew screw (1) and bend
open and remove clamp (2)
– Install parts in reverse order
12.3.4 Support
– Remove drive tube assembly,
b 12.1
: Remove throttle cable holder (1)
– Install parts in reverse order
2
1
545RA271 TG
5904RA540 TG
1
12.4 Gearbox for drive tube
assembly 25.4 mm with
square profile
12.4.1 Removal and installation
– Removing cutting attachment
: Undo the screws (1)
: Pull gearbox (2) off of drive tube
assembly (3)
– Examine gearbox, repair or
replace if necessary, b 12.4.2
5904RA466 TG
3
1 1
2