Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
118 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
Installation
: Insert clamp (1) in loop handle (2)
– Fit screw
– do not tighten
– Install drive tube assembly,
b 12.1
: Orient loop handle (1) at a
distance of approx. a = 35 cm
from control handle and tighten
screw (arrow)
– Reassemble remaining parts in
reverse order
5904RA485 TG
1
2
1
5904RA543 TG
a
12.3 Deflector
12.3.1 Deflector for gearbox
with 25.4 mm drive tube
assembly diameter
To preserve the threads in the
plastic parts, screw the screws into
the existing threads and tighten
carefully.
: Remove screws (1)
: Remove plate (2) and deflector
(3)
: Unscrew the bolt (1)
– Push out mount with line limiting
blade
5904RA487 TG
3
1 1
1
1
2
5904RA488 TG
1
: Unscrew the bolt (1)
: Slide line limiting blade (2) down
slightly and remove
– Examine line limiting blade,
resharpen or replace if necessary
: Press tab (1) and slide out
strip (2)
– Examine gearbox, repair or
replace if necessary, b 12.4.2
5904RA489 TG
1
2
5904RA490 TG
2
1