Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
116 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
12.2.2 Disassembling the drive
tube assembly with a
diameter of 28 mm
– Remove the drive tube assembly,
b 12.2
– Remove bike handle, if
necessary, b 9.2
– Remove 4-point antivibration
system, if necessary, b 9.2
: Undo the screw (1)
: Pull gearbox (2) off of drive tube
assembly (3)
: Pull drive shaft (1) with serration
out of the drive tube assembly
If the shaft has blue tarnish on it, it
must be replaced.
2
5904RA475 TG
1
3
5904RA476 TG
1
: Pry out shakeproof washer (1)
– Replace shakeproof washer
after removal
: Pull flexible liner (1) out of the
drive tube assembly
Assembly
: Push flexible liner (1) into drive
tube assembly
5904RA477 TG
1
5904RA478 TG
1
5904RA479 TG
1
: Push flexible liner (1) inside the
drive tube assembly until depth a
= 25 mm
: Push new shakeproof washer (1)
inside the drive tube assembly
until depth a = 6 mm
a
5904RA480 TG
1
a
5904RA481 TG
1