Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
111FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
: Pull off the fuel return line (1) at
the connector (arrow)
Always use a new fuel return line.
: Unscrew screw (1) and remove
fuel tank (2) downward
Only reuse those parts of the old
fuel tank which are not supplied with
the new fuel tank – see spare parts
list.
– Check tank vent, replace if
necessary
1
5904RA457 TG
1
5904RA458 TG
2
Installation
: Insert the engine unit (1) in the
fuel tank (2) so that the
domes (arrows) on the starter
and ignition side engage the
recesses of the fuel tank
: Screw in the screw (3) and
tighten
: Fit protective hip plate (2) so that
the bulge is at the tank filler port
: Insert and tighten down the
screws (1)
1
3
5904RA459 TG
2
1
1
1
5904RA460 TG
1
2
: Push connector (1) into the fuel
suction hose (2) so that the fuel
hose (3) is between the
ribs (arrows)
– Connector must be pushed all
the way into the fuel suction hose
: Push the new fuel return line (1)
completely onto the
connector (arrow)
– Reassemble remaining parts in
reverse order
3
1
5904RA455 TG
2
1
5904RA438 TG