Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
109FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
11.9.2 Fuel hose
– Open the filler cap
– Remove filter housing, b 11.2
: Pull out connector (1) with fuel
hose (2)
– Remove the carburetor, b 11.3
: Pull off fuel hose (1) with
connector at the
carburetor (arrow)
– Pull connector off of fuel hose
– Remove the pickup body,
b 11.9.1
5904RA409 TG
1
2
5904RA437 TG
1
: Pull the fuel suction hose (1) out
of the inside of the tank
: Pull off the fuel return line (1) at
the connector (arrow)
Always use new fuel hoses.
Installation
: Push fuel suction hose (1) into
hole (arrow) in fuel tank
1
5904RA439 TG
1
5904RA440 TG
1
5904RA449 TG
– Use STIHL press fluid to simplify
assembly, b 14
: Orient the fuel suction hose (1)
and press it into the hole in the
housing as far as it will go – the
flange must be flush with the
guide (arrow)
: Push the new fuel return line (1)
completely onto the
connector (arrow)
1
5904RA450 TG
1
5904RA451 TG