Operators Manual
Table Of Contents
- Contents
- 1. Introduction and safety precautions
- 2. Specifications
- 3. Troubleshooting
- 4. Clutch
- 5. Engine
- 6. Ignition system
- 6.1 Ignition timing
- 6.2 Ignition module
- 6.3 Testing the ignition module
- 6.4 Spark plug boot / ignition lead
- 6.5 Flywheel
- 6.6 Short circuit wire
- 6.6.1 Testing
- 6.6.2 Short circuit wire on engine, removal and installation
- 6.6.3 Short circuit wire with M-Tronic on engine, removal and installation
- 6.6.4 Short circuit wire on control handle for loop handle, removal and installation
- 6.6.5 Short circuit wire on control handle for bike handle, removal and installation
- 6.6.6 Ground wire
- 6.6.7 Contact spring versions with control handle for bike handle
- 6.7 Troubleshooting, Ignition System
- 7. M-Tronic
- 8. Rewind starter
- 9. Antivibration elements
- 10. Actuating levers
- 11. Fuel system
- 12. Drive tube assembly
- 13. Special tools
- 14. Service accessories
10 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
3.3 Drive tube assembly
Problem Cause Remedy
Drive tube assembly vibrates Flexible liner is worn
– Drive shaft is insufficiently
supported and can vibrate
Replace flexible liner
Cutting attachment out of true Resharpen cutting attachment
evenly, replace if necessary
Drive tube assembly becomes very
warm
Drive shaft not sufficiently
lubricated
Lubricate drive shaft along its entire
length – the entire length of the
flexible liner must be lubricated
Bike handle does not clamp Clamps are greasy or oily Clean clamps and bike handle
Bike handle can no longer be
adjusted
Clamps are dirty Clean clamps and bike handle