Operation Manual

:KHQHQJLQHEHJLQVWRILUH
if FROG:
 Turn filter cover counterclockwise
until mark points to N - then
continue cranking until engine
starts -
if ZDUP:
continue cranking until engine
starts -
$VVRRQDVHQJLQHLVUXQQLQJ
if FROG:
•
Press throttle interlock -
•
Let engine run at full throttle for a
few minutes to warm up -
•
Release throttle interlock -
•
Turn filter cover to 581 -
engine idles -
if ZDUP:
•
Press throttle interlock -
•
Squeeze throttle until tab
disengages - engine idles.
If the carburetor has been set correctly,
the cutting tool should not rotate when
the engine is idling!
The unit is now ready for use.
6ZLWFKLQJRII
•
Slide stop switch to position .
$WYHU\ORZWHPSHUDWXUHV
/HWHQJLQHZDUPXS
When engine has started:
•
Let it run at full throttle for a minute
to warm up -
Release throttle -
Turn filter cover to 581,
engine idles.
,IHQJLQHGRHVQRWVWDUW
Filter cover was not turned to 581
quickly enough after engine fired for the
first time, engine has been flooded.
•
Turn filter cover to 581 -
•
Set starting throttle position -
•
Start engine -
pull starter rope briskly -
10 or 20 pulls may be needed -
,IHQJLQHVWLOOGRHVQRWVWDUW
•
Slide stop switch to position 
 Pull off spark plug boot -
•
Unscrew and dry spark plug -
•
Open throttle fully -
•
Pull starter rope several times to
clear combustion chamber -
•
Refit spark plug -
•
Connect spark plug terminal -
•
Slide stop switch to position  -
•
Turn filter cover to 581 even if
engine is cold! -
•
Restart the engine.
342BA033 KN
9
1
)6 