Operation Manual

67,+/3RO\FXW
 Insert locking nut in cutting head
 Screw cutting head as far as
possible clockwise on
 the shaft -
•
Block the shaft -
•
Tighten the cutting head securely.
,PSRUWDQW
Remove the locking pin!
$GMXVWLQJWKHQ\ORQOLQH
RQWKH67,+/$XWRFXW
•
Hold the rotating cutting head
parallel to the overgrown area -
lightly tap the ground - the line is
adjusted by approx. 3 cm -
Excessively long nylon lines are
shortened to the optimum length
by the
 cutter on
 the deflector -
Do not tap the ground several times
in succession!
•
The line is only adjusted when ERWK
nylon lines are DWOHDVWFP long!
RQWKH67,+/3RO\FXW
•
As described on the instruction
sheet supplied with the cutting head
5HPRYLQJWKHFXWWLQJKHDG
•
Block the shaft -
•
Turn the cutting head
counterclockwise.
5HSODFLQJWKHQ\ORQOLQHRU
FXWWLQJEODGH
•
As described on the instruction
sheet supplied with the cutting head.
342BA024 KN
1
2
2
6
342BA000 KN
7
)6 