Instruction Manual

FS-MM
English
9
Mounting the MultiTool
Remove the gearbox
N Loosen the clamp screws (1) and
pull the gearbox (2) off the drive
tube.
Remove the deflector
N Loosen the screw (3) and pull the
deflector (4) off the drive tube.
WARNING
Keep the deflector in a safe place and
always refit it before using other
MultiTools – there is otherwise a risk of
accidents.
N Push the coupling sleeve (1) onto
the drive tube (2) as far as stop.
The coupling sleeve (1) is properly
positioned when the arrow is in line with
the gap in the flange (4).
N Tighten down the wing screw (3)
firmly.
Removing the MultiTool
N Loosen the wing screw and pull off
the FS-MM.
N Push the deflector (1) onto the drive
tube (2) as far as stop.
N Tighten down the screw (2).
N Push the gearbox (3) into position
and tighten down the clamp
screws (4).
N Tighten the two clamp screws on
the gearbox in the following
sequence:
– Tighten the first screw moderately.
– Tighten the second screw
moderately.
Fitting, removing the
MultiTool
1
486BA012 KN
2
1
3
486BA013 KN
4
2
9911BA002 KN
1
3
9911BA004 KN
4
1
2
9911BA011 KN
4
9911BA008 KN
3
481BA011 KN