Operation Manual

FS 510 C, FS 560 C
English
25
Thrust plate
60 mm (2.4 in) diameter (A) version
for mounting mowing heads and
grass cutting blades
65 mm (2.6 in) diameter (A) version
for mounting brush knives and
circular saw blades
NOTICE
The thrust plate is necessary for
mounting all cutting attachments to the
gearbox.
Thrust washers
60 mm (2.4 in) diameter (A) version
for mounting grass cutting blades
and circular saw blades
70 mm (2.8 in) diameter (A) version
for mounting brush knives
Rider plates, guard ring and nut
Approximately 80 mm (3.2 in)
diameter (A) rider plate (1) for grass
cutting blades
Approximately 63 mm (2.5 in)
diameter (A) rider plate (2) for
circular saw blades
Guard ring (3) for brush knives.
Both these parts have the same
function:
Nut (4) and thread on shaft are
protected against wear.
Ground contact with metal cutting
attachment is minimized.
Rider plate allows cutting
attachment to glide along close to
ground.
WARNING
Always replace a worn rider plate and
guard ring in good time.
Nut and combination wrench
Metal cutting attachments are mounted
to the gearbox with the nut (4).
N Loosen and tighten the nut (4) with
the combination wrench (5).
WARNING
If the mounting nut has become too
loose, fit a new one.
Cleaning the Gearbox and Cutting
Attachment Mounting Hardware
Clean the gearbox, the area surrounding
it, inside the grass shield and the cutting
attachment mounting hardware at
regular intervals. Also check for
contamination when changing the
cutting attachment and clean thoroughly
if necessary.
N Remove all cutting attachment
mounting hardware from the
gearbox for this purpose.
681BA188 KN
A
A
681BA189 KN
A
A
681BA191 KN
4
3