Operation Manual
FS 56, FS 56 R, FS 56 C, FS 56 RC
English
18
Mounting the Handlebar
Mount the handlebar on the drive tube
about 10 cm (4 in) forward of the engine
housing.
N Place the handle support (1) on the
drive tube (2).
N Place the handlebar (3) in the
handle support.
N Fit the clamp (4) on the handle
support. Insert the screws (5)
through the holes in the parts and
screw them into clamp (6) as far as
stop – tighten them only moderately
at this stage.
Mounting the Control Handle
N Take out the screw (1) – the nut (2)
remains in the control handle (3).
N Push the control handle onto the
handlebar (5) until the holes (6) line
up – the throttle trigger (4) must
point towards the gearbox.
N Insert the screw (1) and tighten it
down firmly.
Adjusting and securing the handlebar
N Align the handlebar so that
distance (A) is about 20 cm (8 in)
and distance (B) about 15 cm (6 in).
N Tighten down the screws (1) firmly
in a crosswise pattern.
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
Mounting the Bike Handle
4
5
1
6
3
2
002BA274 KN
3
6
547BA027 KN
1
2
4
6
5
A
1
B
002BA275 KN