Instruction Manual

1
0000099346_001
2
3
► Fit the thrust plate (2)
► Turn the mowing head anticlockwise on the
shaft (1) as far as it will go
► Push the offset screwdriver (3) into the hole in
the gear as far as it will go; press lightly
► Turn on cutting tool until the offset screwdriver
engages and the shaft is blocked
► Tighten the mowing head
NOTICE
Remove the tool that was used to block the
shaft.
8.4 Removing the Mowing Head
► Block shaft with offset screwdriver
► Turn the mowing head clockwise
8.5 Mounting the Metal Cutting
Attachment
WARNING
Put on protective gloves – risk of injury from
sharp cutting edges
Always fit only one metal cutting attachment!
Positioning the cutting attachment
1
2
3
681BA121 KN
The cutting edges of the grass-cutting blades (1)
and (2) may point in either direction – these cut‐
ting attachments must be turned over regularly to
reduce one-sided wear.
With grass-cutting blade (3), the cutting edges
must face clockwise.
WARNING
Direction of rotation is indicated by an arrow on
the inside of the deflector.
0000099347_001
6
4
5
8
9
7
10
► Fit the thrust plate (9)
► Position the blade (7) on the thrust plate (9)
WARNING
Collar (see arrow) must engage the cutting
attachment's mounting hole.
8 Mounting the Cutting Attachment English
0458-233-0121-H 17